Browse By Category
Back to product list
AS Series
Model AS is a ramp & roller type clutch, non-bearing supported. Bearings are required to support axial and radial loads. Lubrication and sealing are required. Nominal outside dimensions are the same as a Series 62 ball bearing.
- The inner race is keyed to the shaft (except for size 6 mm bore).
- The outer race has a positive r6 tolerance to give a press fit in a H7 housing.
- Can accept an axial misalign- ment of inner and outer race of ± S/2.
- These clutches are oil dipped at the factory but must be filled to the proper level before operation.
- This clutch is designed for oil lubrication . For grease lubrication, reduce the maximum overrunning speed to 50% of listed value.
